Questions & Answers for: KitchenAid what does pcb stand for

...plate at the back is stuck in the high position or you need a new phase board. That's the small PCB under the back cover at the

goes too fast...one speed only..fast! Probably needs a new phase board, that's the small PCB under the back cover at the top with all the wires coming out of it.

...stand mixer is spinning too fast after a voltage fluctuation. I was using the mixer to knead dough, I switched it off for a few seconds and when I turned it on again it started going at high speed ...

KitchenAid mixer runs at full speed only It is most likely the phase board which is the little PCB under the back cover at the top, it has 4 wires coming out of it that plug into the black speed ...

...stand mixer only go fast? My well used mixer, as of this morning, operates on speed 1 like it is 10 and only gets faster from there! Throws everything out of the bowl ... is this something that I can ...

...If nothing is sticking in the movement of the control plate at the back I would replace the little PCB at the back just above the control plate. Where I live it is called a phase

...Stand Mixer? Will not power on at all. Remove the top cover, screws are under the metal trim band with the writing on it. Get a multi meter and follow the power. Where the power stops is a good place ...

...5th speed That's not the sort of problem you are likely to solve at home. There is a speed control pcb and a speed sensor involved, it's not mechanical like the other old models. Best you contact ...

stand mixer doesn't work after the 5th speed It will run, but not Past the 5th speed. That's not the sort of problem you are likely to solve at home. There is a speed control pcb and a speed sensor ...

...what you have done is going to require splitting the gear cases to fix. There is sometimes a small pcb between the mains input and the speed control, that's between the cases screwed to the bottom ...