Questions & Answers for: pat coil

non start,turns over ,pats light out,no fault codes evident check fuse for immobiliser.or replace the reader coil around the ignition.if it cannot read the code off the key it wont start.if the key ...

...fuse, Starter, and Coil. Check to see if your truck has a programmable key. It is also called a PATS key. If this is the case the you will have to have the key programmed to your trucks anti

...a crank no start issue ? If so, is the theft light in the cluster flashing ? No mention about the PATS bypass. One try is to put a functioning key in the ign ( in the off position is fine ) and try ...

...a continued problem.. signal work with out key and flasher unit stay on continuous while key off. PATS Transceiver The PATS transceiver is located under the steering column shroud and communicates ...

Remote Start Ford Exp 2003 I have a problem with the PATS system not allowing the remote stars crank the engine. It tries to work till the PATS light on the dash starts to blink really fast then quits

...online and of course, make sure you have battery charged. Could be a bad coil pack. Just follow the path check your fuses Inline ...

i replaced immobilizer coil . still getting theft light code 11 pats system is acting like a jerk .had key reprogrammed. worked for 2 starts then lost connection. tried to reprogram and would not take

...go around it. Which fuses are. Security. Or coil ,ignition There is NO way around this system. The PATS module communicates digitally with the PCM. If the PCM doesn't get the ok from the PATS

...GUESS IS PUMP PRESSURE 0 PSI CRANKING IF opted and present? AND IMMO NOT UNHAPPY RIGHT?> aka PATS failing? scanned "If there is a PATS problem, this indicator will either flash rapidly or glow ...

...flash codes that come on after you leave the ignition on for 45 seconds following a no start due to PATS engaged. DTC B1681 DTC B1681/ 2001 Ford Ranger, 4x4, 3.0L,no start. Theft light flashing ...