Replace BCM and Passlock sensor Just had my 2002 chevy blazer S-10 diagnostic test done it tells me I need to replace the BCM and Passlock sensor codes were U-1016,U-1064,and U-1041, U-1000, The ...
...Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7.) With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. ...
...Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7.) With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. ...
...start the Blazer. PASSLOCK - Reprogramming Auto Learn IMPORTANT: * The Body Control Module (BCM) must be programmed with the proper RPO configurations before performing learn procedures. See BCM ...
Start the engine (the vehicle has now learned the Passlock(TM) Sensor Data Code and/or password). If above procedure does not work, you either have another issue or use of Dealer Tech 2 Scan Tool will
Question about 2001 Blazer
...start then die. please help before i have to put another penny in it. Is it the passlock, bcm or what. there is no chip in my ke I have tried the relearn procedure. My interior lights dont work but ...
...NOT RUN.WITTS END NEED HELP... it will not start if the passlock system says no gas or not. more wiring repairs are necessary to engage fuel pump. the door buzzer and dome light are on the same ...
how to bypass passlock on 1999 chevy blazer Blazer starts and quickly shuts down security tell dos'nt blink just stays lit i have tryed the reset fix did not work changed fuel filter and replaced ...
Question about 1998 Blazer
start: The Passlock System can be reactivated by turning the modification switch OFF (contacts closed). Vehicle can either be running or off when this is done. Please note that the VCM/PCM will record
...start t replaced brake booster and forgot to disconnect the battery and unplugged some wires This is a Passlock system. See this post on how it works, what goes wrong and how to do a reset ...
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
