Questions & Answers for: parking brake light hyundai elantra

...capacity. The brake light is next in sequence with the battery light, and will glow dimly. (Set your parking brake, and it will glow brighter.) I replaced the alternator, and cleared up the

...to be 'dual filament' - two contacts on their bottoms). When you step on the brake pedal, do your dash lights LIGHT UP? A 'cross circuit' exists between brake lamp circuit and parking lamps

My 1998 Elantra GLS Wagon doesn't always come out of Park when I step on the brake dear friend:i think you must hook up to a scanner for the fault code,it might be the brake light switch that is ...

...parking brake light came on at the same time. what does this mean? my P-brake isnt on either. but when i do put it on the dash signal gets brighter. i know this is a message for something If the ...

...parking lights (and don't have my foot near the brake). What would cause this? The rear brake light/park bulb was installed incorrectly make sure the alignment pins on the bulb line up in the light ...

unable to shift from park with engine running and brake peddle depressed. also all the dash lights and park lights come on when the brake is pushed Someone replaced a dual-filament brake lamp bulb ...

...hyundai elantra when I got out my friend noticed my brake lights were still out, so we tried pumping the brakes and nothing happened they still stayed on, finally I pulled the ABS fuse and the lights ...

starts will not come out of park and the lights will not come on or the brake lights wont work but the turn signals work Check the brake light switch just above the brake pedal

parking brake light on all the time? I have checked the operation of the parking brake switch, all ok. 0.6 volts closed contact with brake down. I have checked the brake fluid level, all ok. sensor is

...brake light switch: Even though you have replaced the brake switch, it is still possible that the new switch is defective. Use a multimeter to check for continuity when the brake pedal is pressed. If ...