...to operate with I:gnition and be on during daylight hours. They seem to be intermittent Your parking brake when applied before startup disables DRL. Make sure your parking brake is fully
...the bulbs still don't work. The parking lights and all others work. Check the brake light switch at the top of the brake pedal, also make sure to check for any bad fuses for the brake light
96 cutlass supreme 2 dr. coupe wont release from park also breake lights wont work the brake light issue is probably causing the shifter not to work because when you press the brake it tells the shift
...parking brake cable by lifting up on one end of the cable spring clip to free the end of the cable from the lever. Remove the bolt and washer attaching the cable support brake to the caliper body ...
how do I adjust the rear cliper emergency brakes. you adjust the park brake cable not the brakes, the adjustment is under the car on the drivers side.
...Parking brake lights come on after shifting into drive and moving a few feet Have the ABS codes scanned. Could be wheel speed sensors, however when the parking brake light comes on this is an ...
...going to have to tilt the engine forward. Here is how it's done, with the transmission in park and parking brakes on with a block at the BACK wheels. Undo the two dog bone motor mount at the front
My parking brake light comes on and stays on although the brake is not on Is your brake fluid level a little low?
parking brake with the vehicle parked, engine turned off and transmission in Park. Release the parking brake completely, then apply it again, and ensure that it is fully released. Turn the ignition on
I have a 1995 Cutlass and when I push the brake, it won't shift out of park Sounds like the solinoide on the shifter is not disengaging the lock so the shifter can be shifted out of park. The ...
Usually answered in minutes!
697 Questions
571 Questions
488 Questions
387 Questions
236 Questions