...paper feed sensor (located in the center of the paper entry) you may have some paper jammed behind it. If your machine has electronic sensors (little glass bulds located in same area) your paper feed ...
paper on a sensor. 1-take out all trays ( or open and look from both sides ) look at where the paper feeds ( where the tires are) there is a small black lever if lifted will snap back in place, spring
there is a sensor there it may be bad, look for a small black spring loaded lever where you put the paper in it should go back and say it has paper unplug ang plug back w/paper in bad or broken sensor
Question about HL-2070N Laser Printer
...paper sensor is bad the machine will stop feeding and output the error paper jam. This is probably the cuase if the paper stops in the same position all the time. Hi b_schmidt_76 this problem occures ...
...sensor does is indicate if there is paper in the tray or not. The most likely problem is that your paper feed roller,(the rubber roller at the back of the printer in the paper tray area) is embedded ...
...see any obstructions. The paper detect sensor could have dirt in it. Blow canned air directly on the sensor and try again. Asides from the sensor being bad the actuator for the sensor could be
...on then the sensor that the paper trips is bad or the sensor arm is broken or the main board is broken... try reseting the machine and failing that taking it apart and finding the sensor thats
...sensor. 2 bad paper. change paper brand and type. use hammil mill 20# long grain brightness90 and above to test. if this works you need better paper. if not you have a bad jam sensor and need a tech ...
...paper path sensor test" Pay attention to E, it refers to "tray 2 pre feed sensor". You say that you " tried changing Rollers,and all the sensors". I'm confused, does that mean that you tried and ...
Question about LaserJet M4345 MultiFunction Printer
...near the jam had it accurator jammed so the copier thinks there is still a paper there. or you mite have paper dust or dust blocking the sensor. Could also be a bad sensor worst case bad main
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions