Questions & Answers for: Kodak EasyShare paper sensor

...paper sensor around roller, the roller out of runing if the sensor is not senitive enough or sensor switch dirty, clean the sensor as you can find it, 2) Lighter-weight paper feeds and prints fine, ...

...sensor for paper jam is causing you problems. Worst thing is that Kodak discontinued the whole 5xxx series because of all the problems those printers had. I don't know if you will be able to fix the ...

tried everything from 1 sheet to 20 sheets of paper, cleaned the roller. Hand forced the paper in and nothing works. Any ideas? The paper sensor in the printer might be disturbed please check that one

load paper message even when paper is installed in paper tray. i have a kodak dock printer 3 you need clean your printer properly some dust particles in paper sensor could cause its malefunctioning

...paper through the printer. d) The Media Sensor will be re-calibrated, however it will not give any indication that it was. There will be no message saying that it was successful. Yours sincerely, ...

...Paper reaches a sensor and never leaves it. 2) Paper does not reach the sensor in the time allotted. A simple test is to put a mark on the next page that should be pulled from the paper tray. If the ...

...paper all the way through without printing anything on it. Is is repairable or should I purchase a new one? There is a faulty sensor inside of the circuit so a new printer would be better to invest ...

paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor

...paper feed sensor is faulty .this sensor switch is triggered by the paper once inserted.the sensor must be clean with a paint brush to remove dust. run the printer diagnostic software input a test ...

paper jam without having paper in it paper sensor may dusty