paper stuck up Paper is stuck while tsking out paper part ot stuckup and the machine does not respond for printing Hi, Hope this will give you hints. When is the paper got stucked? Both paper feed ...
...paper there, start printing". If this sensor is not working properly you will get the error that you are receiving. Most of the time the light still comes on but the sensor board cannot process. You ...
Question about OfficeJet G85 All-In-One InkJet Printer
...it and then turned bacvk on and it still says paper jam there is still a piece of paper on a sensor or a sensor is bad look for a sensor like this it should have the flag in the UP position as
...paper sensor (the spot sensor) is located on the printhead carriage, to the right of the cartridges. It is a small black box. If you try to do an alignment with the top cover open, you can see the ...
sensor. 2) A paper feed operation was called and no paper showed up at the first sensor in the time allotted for it to travel to the first sensor. If you don't find a jammed piece of paper, look for a
Question about Officejet Pro L7580 All-In-One InkJet Printer
...sensor. 2) A paper feed operation that does not send paper into the printer will get reported as a jam it the paper does not reach a sensor in the time that is allotted to reach the sensor. The ...
...is a L7780 printer It sounds like the paper sensor in the paper try is broken or jamed. Remove the paper tray and locate the paper sensor. Check if it is jamed in the up position or if it is
PAPER SENSOR FAULTY Paper sensor faulty - printer doesn't recognise when paper is loaded Cannot print from the glass top. The top load area keeps running and then the message says to reload the ...
Question about Officejet Pro L7580 All-In-One InkJet Printer
paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor
Question about Officejet 4315 All-in-One Printer
...tiny pawl (paper sensor) and try to shake it because maybe when you remove the paper, this sensor is staked in position. Other options are damaged paper sensor or controller board. Good luck ...
Usually answered in minutes!
2,817 Questions
1,584 Questions
1,223 Questions
991 Questions
857 Questions