Questions & Answers for: HP LaserJet paper sensor

Question about LaserJet 4700N Printer

2 Answers

these and let me know what happens. The paper tray paper sensor may be stuck, and does not sense that the tray has lifted into position? Look for a stuck paper tray sensor, or broken sensor arm / part

Ad

Question about LaserJet 3030 All-In-One Printer

1 Answer

...are swinging freely, and not stuck in a open or closed position, which is what I suspect. If the paper pick-up does not even start to pick up the paper, then likely a paper sensor is stuck, or

Ad

Question about LaserJet 1300 Printer

1 Answer

...Computer is telling me there is a paper jam. However I can't see the paper check the sensor, could be somthing stucking on the sensor or the sensor itself could be out of place. but its sensor ...

Question about Color LaserJet 3500 Printer

2 Answers

...SENSOR B = PAPER LOOP SENSOR C = N/A D = FUSER PAPER SENSOR E = DELIVERY-TRAY PAPER-FULL SENSOR F = FUSER PRESSURE-RELEASE SENSOR G = MEDIA SENSOR H = N/A I = MP TRAY SENSOR J = CASSETTE SENSOR K = ...

Question about LaserJet 4 plus Printer

2 Answers

...sensor is defective. 13.14 For Laserjet 5si. This error is caused by a defective paper control PCA Replace paper control PCA. 13.20 Paper Jam Check Rear Door Media stopped in the paper path during ...

Question about LaserJet P3005n Printer

1 Answer

...stating that there is a paper jam, but there is not a paper jam! What should I be looking for? Paper path sensors dusty, clean all paper path sensors as well as verify sensor flags &

Question about LaserJet M4345 MultiFunction Printer

1 Answer

...paper path sensor test" Pay attention to E, it refers to "tray 2 pre feed sensor". You say that you " tried changing Rollers,and all the sensors". I'm confused, does that mean that you tried and ...

Question about LaserJet P4015N Printer

2 Answers

...paper sensor. can be one of the following locations. ? TRAY 2 Remove the tray, and then check the paper path for obstructions. Perform a manual sensor test and observe the prefeed sensor (PS102) ...

paper sensor located under the registration assembly.. In case this sensor dusty malfunction or flag damage, paper wont sense. result paper damage..3.Fusing area. If the paper travels up to fuser

Question about Color LaserJet CM6040f MFP Q3939A Printer

1 Answer

...paper stopped at either the loop sensor (E), the fuser-output sensor (F) or the switchback sensor (G). E & F are just prior to the paper going into the duplexer. G is a sensor in the duplexer ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...