Question about DesignJet 450c InkJet Printer
...paper through and align it with itself and with the dotted line to the right of the plotter, then it will accept it. Sometimes takes several tries. Sheet problems may be caused by dirty sensors. Good ...
...cleanot assy have paper jam sensors and if sensor damaged you have problem whit paper jam !! make sure that you are inserting the paper into the correct slot in the back of the machine. Good
...the printer to not be able to track where the paper is. Replacement of this sensor requires a certain amount of technical confidence as you will need to disassemble a certain amount of the
...paper sensor due to dust, don't open any thing just high pressure air pump required(ex bicycle pump)blow on sheet paper path sensor located just left above of paper roll path(look black "U" ...
...sensor' and retry.this is a quick process which sets the values for paper present/not present on the formatter. c:- if the above two have failed then order a new PCA and calibrate the sensor ...
...sensor to black but does not print pattern and says "return error: 2". I have seen this error occur when the carriage does not move smoothly left to right...are the shafts properly lubricated and the ...
..."see" the reflection from the paper. If cleaning the sensor (it is on the RH side of the carriage) doesn't resolve the problem, then the sensor would need replaced, if it is still available that
...paper no longer detected reinsert sheet into feeder, the single sheet senor has been replaced with new, the firmware level has been updated to 08:02:02:03, eerom reset has been carried out, error is ...
...server/computer to the printer. Remember, Stock rolled paper has different physical characteristics than Vellum. Also this will aid on the paper sensor to note what type of paper you are printing ...
Usually answered in minutes!
125 Questions
147 Questions
140 Questions
140 Questions
87 Questions