Questions & Answers for: TallyGenicom paper sensor

...paper motion sensor calibration, try the following: · Check the back of the form along the left side to ensure there are no black (dark) areas in the area of the tractor drive holes. (If there are, ...

paper width sensor, the paper width sensor on the 2280+ is locate on the carriage and detects when you try to print off the paper. You may wish to disable the paper width sensor. To continue printing,

paper width sensor so the edge of the paper is not detected and the error is no seen, the paper width sensor can be disabled in the following way.Power printer OFFHold down the ONLINE button and power

...paper out error message let me do what? Please help! thank you in advance. This sensor can be re-calibrated. Press LF and Enter for 5 seconds to enter Tech access mode. Press menu scroll to test then ...

...Paper Width Sensor will clear the error but may cause the printer to print on the Platten which may reduce print head life, the Paper Width Sensor can be disabled in the following way; Start with the ...

paper out even with paper in. Is there a hidden sensor YA. 1. REMOVE POWER SUPPLY UNIT OF THE PRINTER 2.IT WILL APPEAR IN THE RIGHT HAND SIDE 3.JUSY ADJUST THE SENSOR 4.OTHERWISE CONTACT(+919910959233

...Paper Width Sensor. The Paper Width Sensor is located on the print head carriage and detects the paper edge to prevent printing on the platen. You can check the follwoing; Ensure the print head cable ...

Paper out prolems end solution for TallyGenicom 6312 When start the impriment the alarm is PAPER OUT and LED on the top of command is RED try no align sensor of paper in pack left of platen

[email protected] There is one Sensor at upper part of Platen where the Paper comes.. this sensor can be seen after pull back one white strip where the paper comes. clean this

...Paper Out Sensor, in the Tech Access Menu, Press the LINE FEED and ENTER buttons for five seconds until the printer flashes up TECH ACCESS on Then access the menus as described below. Press the MENU ...