...paper empty sensor which hangs down, make sure you take out the tray and look for any pieces of paper stuck.2- open right door and look as if your looking inside to where the paper is supposed to end ...
...paper on a sensor 2- a sensor is bad try to locate the sensors and look carefully there should be no more than three on this model 1-in the paper tray so it knows there is paper in the tray 2-under ...
...same step for simulation 40 sub code 01,that's for by-pass paper path sensor. After you done those procedure you will find out which sensor block out or defect, good luck. HAVE A HAPPY HOLIDAY
...sensor presence of the paper does not see bumagi. if she there is in pallet, signifies the sensor does not see her(it). In other words, there is two reasons, the first beside you pallet is installed ...
...sensor that detected a paper jam has not reset itself after removing the paper. Make sure that when the jam was removed - all the paper came out and there is/was not a small piece missing that could ...
Question about AR-5316 Advanced Digital Imager Copier
...not broken. also open cassete and see inside no paper jam there check your sensor connector or clean sensor or small black thing is on there, in own place. check the sensor with simcode 30 - sub ...
Question about AR-5316 Advanced Digital Imager Copier
...paper end sensor is broken in the tray. take the paper tray out and you will be able to see a sensor on top. when the tray is fitted the sensor is on top of the paper. the paper lifts the sensor to ...
...sensor 1. paper sensor It is called paper sensor its installed paper tray 2.Drawer sensor 3. Drive sensor its installed middle position 4. Exit sensor it is in fuser unite. May be any sensor displace ...
Question about AR-5316 Advanced Digital Imager Copier
...that b4 it roll out completely the paper will stop and it will be showing paper jam. Check the heater sensor an replace it Check the heater sensor is in own place, clean sensor, check connector ...
Question about AR-5316 Advanced Digital Imager Copier
...sensor it indicates a paper jam when it mite be that the paper was never picked up, switch paper tray does it work then if so clean the rollers or have them replaced by a tech. or that sensor mite be ...
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions