..."check film" error - it seem to get stuck. I installed new film but the problem continues. Thanks! Fred dear sir the film sensing sensor and paper path sensors are abnormal or dusty pleaz check ...
Question about KX-FL521 Plain Paper Laser Fax
...sensor in paper tray .u will see just its lever at the other end of lever there is a sensor .i think it is dirty .just clean it properly.now when u will put paper u will listen beep.now sensor is ...
...paper path to detect timing and position. The sensors are actually optical but the utilize sensor"flags" to interrupt the sesnors light "beam". These sensor flags tend to pop out of position and/or ...
Question about Panafax UF-585 Plain Paper Laser Fax
...it's about to print and then get alarm and same error message. How do I get this to work again? look at the paper tray,some of your sensor are jammed,try tyo find out where is the sensor on paper ...
...sensor in the scanner "looking" up, so dust sits on it untill it thinks its paper. slide in a cotton bud or blow air in the small recess between the 2 black exit rollers visable where the paper exits ...
...It grinds when starting up and says there is misfed paper. Don't see any. Paper feeder sensor guide is open or displace ,So it said misfed paper.Clean sensor or right position set the sensor
...paper sensor,.then it has to be replaced if paper sensor is cracked or bent.but if paper sensor is got moved from its position then readjusting the paper sensor position will help. you can get your ...
...in tray but messege displyed. Sensor for the first paper draw that detects paper has dust or dirt on it or has failedand requires replacement clean with can air or sensor acutator is missing or ...
Question about KV-S2046C Pass-Through Scanner
...paper jam. one thing that error occurred when sensor key stuck or sensor covered with dust, one way to check is general preventive maintenance procedure, remove all back and side cover need vacuum ...
Question about KV-S2046C Pass-Through Scanner
...paper. That is the sensor flag. Slide a piece of paper in and make sure that it pushes the sensor flag backwards. If it does, the sensor is probably coated with paper dust. Use canned air to blow air ...
Usually answered in minutes!
237 Questions
232 Questions
180 Questions
101 Questions
105 Questions