Question about EASYSHARE 5300 All-In-One InkJet Printer
...paper sensor around roller, the roller out of runing if the sensor is not senitive enough or sensor switch dirty, clean the sensor as you can find it, 2) Lighter-weight paper feeds and prints fine, ...
Question about EASYSHARE 5300 All-In-One InkJet Printer
...phone number either! Hello sir; go to find out where is the paper sensor, you will find out there have a small paper chip stuckover there. the paper sensor right in front of paper feeding roller
...Paper reaches a sensor and never leaves it. 2) Paper does not reach the sensor in the time allotted. A simple test is to put a mark on the next page that should be pulled from the paper tray. If the ...
paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor
Question about EASYSHARE 5100 All-In-One Printer
paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor
paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor
Question about 6150 AllInOne InkJet Printer
...to clear rear paper jam but there is no paper jam powered off and on removed rear feed replaced does same error the paper sensor is blocked i hope,try to unzip the printer and check the paper
...by small 'sensors', usually small metal or plastic strips. If a sensor is jammed it will give this message. Another possibility is that you have a small piece of paper stuck where a sensor
printer reads paper jam, no paper jam anywhere Check all the sensors along paper way, clean them with vacuum (sometimes it could be paper dust on sensor's optics).
Question about ESP Office 2150 All-in-one Printer
...sensor flag down, telling the machine that there is paper loaded. either the sensor flag is broken off or there is something jamming the paper sensor, keeping it from being pushed down by the
Usually answered in minutes!
1,024 Questions
996 Questions
1,049 Questions
812 Questions
732 Questions