...paper sensor failed. I don't know if it is the light source (an LED?) or the light sensor. Before I try to take it appart, does anyone know if the parts are replaceable! Good thing I was near it when ...
...paper feed sensor (located in the center of the paper entry) you may have some paper jammed behind it. If your machine has electronic sensors (little glass bulds located in same area) your paper feed ...
...paper in sensor is located, or there is paper fibers covering the paper in sensor, or the paper in sensor is defective. The paper in sensor is usually located in the center of the shredder where you ...
Question about Powershred C-220 Strip-Cut Shredder
...sensor that detects the paper and it is dirty. The sensor will be in the proximity of wher you are shining the light. It is likely covered with paper dust (hopefully only on the outside) Locate the ...
paper sensor failure! The paper sensor is obviously failing ! Is it possible to check this out and/or replace it ? If so with what and from where can it be obtained? Don T Try this it may work. Take ...
...paper bits it blocking the sensor from seeing that the shedder is clear the sensors get dusty from the 'paper lint' . blow out the sensors and the shredder will turn off It worked!!! Now my Fellowes ...
I have a brand new P58Cs and it runs continuously instead of cutting off after paper has passed through - The Fellowes website says to clean the sensors (already, after just one day??) but because of ...
OUR FELLOWES CROSS CUT SHREDDER WILL KEEP ON RUNNING AFTER THE PAPER HAS BEEN SHREDDED. ARE THERE SENSORS THAT COULD POSSIBLY BE COVERED IN PAPER DUST? If you look into the slot you feed the paper ...
...paper in it trips the sensor. this sensor get covered up with fine paper clippings unplug machine and take some compressed air or maybe a q-tip and clean the sensor. should be two right across from ...
...upside-down and remove the screws holding the shredder head cowling together. Open the cowling and you will see the slot where the sensor fits (on one side of the paper feed slot bottom
Usually answered in minutes!
61 Questions
64 Questions
52 Questions
31 Questions
23 Questions
