...paper sensor. If you know how, I will appreciate that info. Thank you! Roger Normally the paper sensor is a leaf switch which gets operated by weight of paper being pulled in the paper movement ...
...paper on a sensor to keep it shut down. 2. And what I suspect more is a dislodged sensor flag. Look carefully for black channel sensors in the paper path. One of the flags is, A. knocked of and needs ...
...sensor arm, or dirt or paper dust on photocell typr sensors.Paper sensors are normally located near where paper feeds, and where it exits the machine. The paper must pass over these sensors as it ...
... and reload it check the paper sensor in paper tray, somtimes when you slide paper in to the tray it pushes under the sensor and holds it up, it is supposed to sit on top of the sensor and push it ...
...paper sensor somewhere in the paper path. If it is giving a paper out message- and doesn't even attempt to pull a sheet from the tray, then there is a sensor there which isn't functioning. If it does ...
...sensor to open ( paper passes the sensor ) at a very specific point in time. If the paper did not get picked up from the tray, then the printer will ASSUME that the paper must be jammed somewhere ...
Question about HL-2070N Laser Printer
...paper sensor is bad the machine will stop feeding and output the error paper jam. This is probably the cuase if the paper stops in the same position all the time. Hi b_schmidt_76 this problem occures ...
...paper path a sensor has gone bad or ther eis a small piece of paper still in the path. I would suggest that you go to teh brother site and download the user manul for this model. It will diagram the ...
Question about IntelliFAX 1270E Plain Paper Fax
paper jam sensor. My suggestion, take a thick piece of card stock and manually feed it through the paper path; this should hopefully clear any debris that is blocking the jam sensor in that area. Also
paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions