paper path. What I would suggest is taking out the toner and drum cartridge, then remove the paper tray. Tip the machine on it's back and look into the paper feed area for something blocking the paper
PAPER PATH" selected in the printer driver box or printer preference or application used is not set correctly to grab the paper from the correct path. 3. The paper path sensor is defective which means
...paper path either before the laser unit or on the final path (look carefully at the little paper separator fingers) that is impeding the paper run at one side? Does the bypass tray give good or bad ...
...paper path, check paper path is clear, one notices where paper beginds to go side ways and there is the block, turn upside down to remove any object, if this fails clean rubber feed rollers with damp ...
Question about PIXMA MP240 All-In-One InkJet Printer
...paper path, normaly you have some sensor stucked. you can check all paper path inside printer, there is a paper door nearby power input. open-it and locate the sensors small plastic finger check for ...
Question about PIXMA MP240 All-In-One InkJet Printer
...some pice of paper struck in the sensor thats why paper jamed lit up clear the whole paper path it will solve problem if not there is any path sensor not working good just clean the path sensors ...
...some pice of paper struck in the sensor thats why paper jamed lit up clear the whole paper path it will solve problem if not there is any path sensor not working good just clean the path sensors ...
...jam. Looked and looked. Its a Gestetner dsm618d. hi if u cant find any bit of paper in paper path may be any path sensor out of order or may be dusty sensor just clean the all paper path sensors ...
Question about MX340 AllInOne InkJet Printer
...paper path. Firs, open ADF access cover and check if some broken paper present inside paper path. If no broken paper found in paper path means paper sensor is faulty and you need got new ADF ...
Question about MX340 AllInOne InkJet Printer
...it gives the same . check paper path rather than just the paper tray. Check duplexer and any other paths the paper takes There will be levers of some kind to open path of path through the printer
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions