paper will not feed through. Any suggestions? Thanks, i am having the same problem and after looking it over, something is not feeding it thru the beginning of the paper starting in. if i pust 1 sheet
...feed my paper will not feed after printing just hear rollers runing but no paper feed I tried reboot download drivers again and no paper jam Check for a jam again somewhere in printer unit, rollers, ...
...you can offer. Yup rubber feed rollers can be replaced of even try just cleaning rubber with slightly damp cloth to remove paper dust that causes them to slip and not grip and feed paper as they ...
...paper, and press the Form Feed button. (On the X83, press the Select button.) Watch the paper as it feeds through and try to determine where the jam is occurring. Check to see if all the rollers are ...
...feed paper My Lexmark Z52 won't feed paper. The feeder spins, but it won't grab the paper and move it until I push each sheet about an inch down and then it grabs. I cant tell if the texture of the ...
...feed the paper correctly My lexmark X 1150 pulls the paper in at an angle to the right and and than jammes every time. What is wrong? Can I do anything to fix it. I suggest you get a sheet of Card ...
paper, and press the Form Feed button. (On the X83, press the Select button.) 4. Watch the paper as it feeds through and try to determine where the jam is occurring. 5. Check to see if all the rollers
Question about JetPrinter Z11 InkJet Color Printer
...feed the paper properly. It My printer will not feed the paper properly. It pulls the paper only on the right side resulting in paper jams. There must be a jam on the left side then. Open and look ...
...Paper feed problem, Either the printer is out of paper: a Load paper. OR b Press the Paper Feed button. ? If the paper is jammed Then Do not load too much paper in the sheet feeder. Depending on the ...
...paper feed mechanism down inside the printer where it is not easily seen. If there is nothing obvious, unplug the printer and remove the paper. Open the front cover and look above the steel rod. You ...
Usually answered in minutes!
542 Questions
147 Questions
54 Questions
43 Questions
38 Questions