...phone doesn't appear to be charging and the bottom of the handset and battery are hot to the touch. It still turns on, has all contact info, dials, and places the call. Is there any hope? It sounds ...
...of the handsets on my Panasonic KX-TG5673 cordless telephones is VERY hot all the time. wellcome,you need to to try and change the phone panel by unscrewing it,because the panel component are
...Panasonic TG2344? 1. call length is diminished 2. battery takes a long time to - or never fully - charges 3. Handset will not turn on. 4. Handset gets hot during use. 5. Approximately 2 years of ...
Question about KX-TG5210 Cordless Phone (kxtg5210)
phone, otherwise you would not be able to move around with it. The battery is probably at the bottom of the handset close to the place where electrical contacts are made (metallic prongs). Look on the
Question about KX-TG2343 Cordless Phone
Panasonic KX-TG2343 phone. Phone seems ok, handset dead. Handset became hot to touch before I took it off charge yesterday. I assume battery has failed. Where do I get a replacement? cordless phone ...
Question about KX-TGA560M 5.8 GHz Cordless Expansion Handset
Hot do you fix Panasonic KX-TGA560M 5.8 GHz Cordless that has nothing displaying on the screen? Cannot hear from handset or earphone, can only hear from speaker phone. What can be the problem.
...still no joy, then it's time to reset the phone. The problem with that is you have to dial the code IMMEDIATELY as you're picking up the handset. Good luck with that. The reset code is 79# or 790. ...
Question about KX-TG5633B Trio Cordless Phone
...Panasonic phones, weak battery will cause the phone to unregister and will give false charge level readings in the display. If your phone gets hot when charging, this is most likely your problem. I ...
battery very hot never fully charges [1] next battery very hot never fully charges [1] next to time, above phone book Try replacing the batteries (think they are 2 AAA's in there)
handset, remove the main board, separate slowly the display screen from the main unit. whit a hot air gun, give some hot to the white flex on the main board side(not too much or you can destroy that).
Usually answered in minutes!
3,453 Questions
1,326 Questions
1,157 Questions
1,197 Questions
607 Questions