Questions & Answers for: Oldsmobile Intrigue p0335 ckp sensor

Ad

Question about 2000 Intrigue

1 Answer

...ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft ...

Ad

where is the crank shaft sensor located in a 1999 oldsmobile intrigue with the 3.5 liter engine? (CKP) located at.Center front of the engine,near the base of the engine oil lever indicator.

Ad

...CKP) sensor electrical connector. 5. Remove the CKP sensor bolt (1). 6. Remove the CKP sensor (2) from the engine block: ? Remove the sensor by pulling on the sensor connector. DO NOT pry on the ...

Question about 2000 Intrigue

2 Answers

replacing the MAP sensor?? REMOVAL & INSTALLATION Disconnect the negative battery cable. Locate the MAP sensor and remove the retaining screws Detach the electrical connector. Fig. On the 3.1L ...

How do you replace coolant temperature sensor on an 2001 Oldsmobile Intrigue Removal & Installation To Remove: ECT sensor 3.5L engine Disconnect the battery ground cable. Drain the coolant below ...

...fuel pump( or fuel rail has pressure) 3) and cranks but doesn't start You most likely have a bad CKP (crank position sensor) It's under the starter meaning you have to remove the starter to get to

Question about 2001 Intrigue

1 Answer

...CKP sensor. If so, recheck resistance reading from the PCM connector. Is the reading still okay? * If not, repair open or short in the wiring to the crank Sensor Bnd re-check. If the reading is okay, ...

Don't see the crank position sensor In my 1990 Dodge Dakota 4X4 I have my starter off. I want to replace my crank position sensor, but haven't found where it's at. have a ...

Hi. Where is it upstream oxygen sensor blank 1 sensor 1 oldsmobile intrigue 99 3.5 Bank 1 is where the number 1 cylinder is. This is nearest the radiator on a GM. The sensor should be on the exhaust ...

where exactly is the cam shaft sensor and do I need a dealer to change it? You should only use dealer sensors, but you can go to any mechanic shop The vehicle will stall or fail to start. The vehicle ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...