Questions & Answers for: Nissan Armada p0335 ckp sensor

Nissan armada Tire Pressure Sensor Stays on One of my tire pressure sensors stays on put the pressure is perfect. Any ideas? I have replaced lots of Tire Pressure Monitor (TPM) sensors due to dead ...

how to relace oxygen sensors yourself on a 2004 armada FIRST OF ALL YOU NEED TO RUN ENGINE FOR 5 MINUTES.BECAUSE ITS HARD TO REMOVE OXYGEN SENSOR WHEN THEY ARE COLD. WEAR LONG SLEEVES AND GLOVES SO ...

VDC OFF Light and slip light???? Had the same problem.. After replacing 2 ABS rear sensors with no luck the dealer found that the wheel hub was bad. Somehow one of the teeth inside the wheel hub got ...

IT DIES ALL OFF THE SUDDEN BUT THEN STARTS RIGHT UP AGAIN THEN WONT DO IT FOR DAYS...THEN IT DOES IT AGAIN sounds like you have an intermittent open in your CKP circuit

light just came on when started vehicle. Another code followed P0430. Vehicle seems to run fine. thanks P0430 - Catalyst System Efficiency Below Threshold Bank 2 The ECM or PCM monitors the switching ...

where is p1148 sersor loced at on nissan armada 2004 P1148 closed loop control,, this means the computer does not see closed loop , the problem could be a bad air fuel sensor also called oxygen sensor

where is the crankshaft sensor for a 2004 nissan armada 5.6 lit engine Are the camshaft sensor and the crankshaft sensor the same exact ones? In a 2004 nissan armada?

code p1168 nissan armada 2004 closed loop control fault; when a vehicle is in closed loop, the comuter reads the O2 sensors and regulates the fuel supply accordingly in order to maintain a 14.7 to 1 ...

misfire p0341 nissan armada Error Code: P0341 Description: Camshaft Position (CMP) Sensor A, Bank 1 - Implausible Signal Indication: Malfunction Indicator Lamp (MIL) active. Possible Causes: Wiring ...

...board kept coming back.. Error Code: P0335 Description: Crankshaft Position (CKP) Sensor - Circuit Malfunction Possible Cause: Wiring. Crankshaft position (CKP) sensor. Engine control module