Questions & Answers for: Mitsubishi Galant p0335 ckp sensor

Ad

Question about Mitsubishi Galant

2 Answers

...P0335 - Crankshaft Position Sensor Electrical Error http://www.bba-reman.com/content.aspx?content=NEXT_DTC_P0335 P0340 - Camshaft Positio Sensor Circuit Malfunction http://www.obd-codes.com/p0340 ...

Ad

Question about 1994 Galant

1 Answer

...CKP location? I've got a 1994 Mitsubishi Galant S, it wont start so i took the OB1 codes and one was the crankshaft position sensor. The book i own isn't exactly user friendly being that its designed ...

Ad

Mitsubishi Galant 2002 will not start OBD II pocket scan codes P0340, P0335 & P0300 , I cleared the codes and tried to restart. still will not start, but no codes come up. shouldn't the sensors Crank

i have a 2001 mitsubishi galant 4 cylinder trouble code P0335 just replaced timing belt and will not start Hi, here's the solution: P0335

...P0335: Symptoms: any or all of the following: Vehicle may not start (see above) Vehicle may run rough or misfire MIL illumination Causes: any or all of the following: Damaged CKP sensor connector ...

...P0335 and P0340, camshaft and crankshaft position sensor. I have replaced both sensors with no luck. The car idols as if it was running normal but when in gear and accelerating it acts like its ...

Question about 2001 Galant

1 Answer

...P0335, P0455. Can you tell me what the codes stand for A code P0300 may mean that one or more of the following has happened: Faulty spark plugs or wires Faulty coil (pack) Faulty oxygen sensor(s) ...

...p0335 & p0340 keep coming up. I changed the sensors and had autozone erase the codes but after I turned engine off and started again the codes came back up! Has anyone had the same issue and been ...

Question about 2002 Galant

1 Answer

...P0335 I replaced the crank position sensor. The car started fine for a few minutes. Once engine was turned off it would not restart and I retrieved codes P0335 and P0300 Question: where did you buy ...

...CKP) sensor connector. Check for 5 volts on the Green/Red wire. Reconnect the CKP sensor connector. Check the Black wire for a good ground. Check for B+ on the Red wire. If the Green/Red wire goes ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...