...CKP) sensor, sometimes called an RPM and/or impulse sensor, is used to determine engine speed and Top Dead Center (TDC). This ensures precise ignition timing. The sensor is located at the rear of the ...
1992 Volvo 240 sedan Sometimes Sputters when driving, and sometimes will stall. If I get out and shake it, it will start back up. Then check engine light comes on. Will drive fine for a few day's ...
hur byter jag växellädsolja på hur byter jag växellädsolja på min s80 t6 -99?? har köpt 12 ...
...CKP. Cam Position Sensor. Needs crank and cam sensor signal to work. Need codes pulled at diagnostic port on front fender. Google 'Volvo Code pulling'' or similar, for sites explaining how to pull ...
...P0335 and P0017. We checked the marks again and everything looks on. Car runs, but seems like it lost a little power. Any ideas? oxygen sensor went bad it located on pipes theres one intake and one ...
...p0335 code. Any suggestions? that trouble code indicates that crankshaft position sensor circuit has a fault. check that the 3 wires on the sensor are in tact and area around it is free of oil and ...
...Sensor, CKP Sensor, CMP Sensor, Pickup Coil, Magnetic Pulse Generator, Variable Reluctor, and the list goes on with a few more names. This may make it seem like every single one is tested in a ...
P0335 or P0336 that deals with the crankshaft position sensor or a P1259 which indicates a problem with the VTEC system. Heck you even have a top dead sensor in the vehicle which will pull other DTC(s
...sensor problems. Change it. p0335 relates to Camshaft Position Sensor A ; so I would replace that sensor first. p0336 relates to the sensor being out of range. Also make sure you aren't getting any ...
...P0335? Replaced crankshaft. It cranks, but takes long to start Damaged CKP sensor connector Damaged reluctor ring (missing teeth or not turning due to sheared-off keyway) Sensor output open Sensor ...
Usually answered in minutes!
664 Questions
682 Questions
587 Questions
551 Questions
468 Questions