Questions & Answers for: Suzuki p0335 ckp sensor

...or circuit malfunction The signal does not reach to ECM for more than 2 sec. after receiving the starter signal. The CKP sensor wiring and mechanical parts.(CKP sensor, wiring/coupler

Ad

...CKP) sensor connector. 7) Remove the CKP sensor retaining bolt. 8) Gently rotate and remove the CKP sensor from the engine block. Installation 1) Insert the CKP sensor into the engine block. 2) ...

Ad

...CKP sensor on some suz, are not hall but just a VR coil and you need scope or other very special tool (mag) to test it. on all 1999 here, our Scan tools tells you which is bad. no scan tool? P0340, ...

...CKP SENSOR OR CMP SENSOR OR ECM.your vechicle a timing light can be used and a scan tool must be used. with timing light and scan tool your correct timing should be 10 - 16 degrees BTDC.if timing not ...

Question about 2004 Aerio

1 Answer

P0335 CODE CRANKSHAFT POSITION SENSOR BAD The sensor would need to be tested with a meter. If it is faulty, the engine and - or transmission has to be removed to replace it. You should be able to find

Question about 2005 Aerio SX

1 Answer

...CKP) sensor. Remove crankshaft position sensor (1) from cylinder block (2). are you serious about this, just guessing>? why guess. the ECU will tell you the CKP is bad, why not scan and drive car ...

Question about 2005 Liana 1.6

1 Answer

...P0335 got 335's ????????? or shows zero rpm cranking. if no tools , we can only gue$$ the crank sensor can only be 3 places on all engines. front crank pulley. mid crank loc. or at flyweel, some ...

...CKP sensor is behind the flywheel (must pull transmission and flywheel to get to it) ive posted the photo of that here, on fixya 5 times. searches work. or is the engine the V6? 2.5 (H25 H27engine) ...

CKP crank sensor on the J20a from behind the fly wheel to the top right front of engine. total new J20b engine it is. so , what engine is there. the in 2004 they offered here, the 2.3L and i think the

CKP behind the flywheel (aaahhhcraaappppp)
and
CMP on rear of cam,
so what is 340,well the service manual is clear
why not ask it , NOT/clerks.
340 is CAM, or CMP sensor.
lucky you.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...