...know. I have a mitsubishi but don't know a whole lot about this problem. But this might help: ...
...MFI DTC P0335 and possibly P0340 may be stored due to abnormal wear to the camshaft position sensor support. Oil grooves have been added to the camshaft position sensor support to improve ...
...P0335 - Crankshaft Position Sensor Electrical Error http://www.bba-reman.com/content.aspx?content=NEXT_DTC_P0335 P0340 - Camshaft Positio Sensor Circuit Malfunction http://www.obd-codes.com/p0340 ...
...Sensor (CKP) and Camshaft Position Sensor (CMP) signals with a lab scope. 2. Check the wiring and connections at the CKP and CMP sensor. Potential Causes:Camshaft Position Sensor (CMP) Crankshaft ...
Question about 2003 Lancer
...P0335 and P0340, camshaft and crankshaft position sensor. I have replaced both sensors with no luck. The car idols as if it was running normal but when in gear and accelerating it acts like its ...
...ckp and my cmp and my 12 volt,my groud and the 5volt!but iam not sure i install the sensing plate on the good way or good position!2 side and 2 way is possible!help me tofind a good way?? code p0335 ...
...P0335 I replaced the crank position sensor. The car started fine for a few minutes. Once engine was turned off it would not restart and I retrieved codes P0335 and P0300 Question: where did you buy ...
Question about 1999 Diamante
...CKP sensor from the vehicle. 5. Installation is the reverse of the removal procedure. Reference: Autozone online repair guide: Mitsubishi Galant/Mirage/Diamante 1990-2000, at www.autozone.com Fig.3 - ...
Question about 1999 Diamante
p0335 p0340 ... Next I scanned for codes and had crank cam sensor codes. I check .... 3 ... This video may help ... the sensor is underneath the timing belt cover so it is a bit involved to get to ...
Question about 1999 Diamante
...driving but never stalled completely before the no start happened ...
Usually answered in minutes!
997 Questions
851 Questions
799 Questions
747 Questions
704 Questions