Question about 1998 Diamante
...HO2S and SIG RTN(GND) of the oxygen sensor connector. Voltage should fluctuate between 0.01-1.0 volts. If voltage fluctuation is slow or voltage is not within specification, the sensor may be
...missing. No codes showing,changed plugs,check wires,new fuel pump ,checked fuel regulator.Timing belt was changed 10K miles ago. any suggestions where to go from here? oxygen sensor, had same ...
location oxygen sensor 2 bank 2 2000 mitsubishi diamante ls? There is two of the and they are located on the front and rear of the exaust manifold.
where would bank 1 sensor 2 be located on a 2004 mitsubishi diamante 6 cylinder 3.5L ? This is for the oxygen sensor Driverside rear o2 sensor
...Oxygen Sensor REALLY STUCK syndrome". This is what I call it when I pull on my oxygen sensor wrench with both hands and the oxygen sensor will not budge. That's when you have to get out the "Heat ...
i had mycatalytic converter changed at bank2, i had my oxygen sensors changed but my check engine light is still on any suggestions Have a shop reset the computer.
oxygen sensor the day before you want to change it. Take the car for a trip (errand, commute, whatever), then let it cool down completely. The heat will help the Liquid Wrench do its job so the sensor
...YOU CLEARED THE CODE BY MEANS OF SCANNER AND THE LIGHT RETURNED?CODE PO155 IS FOR OXYGEN SENSOR BANK2 -SENSOR 1 AND IS LOCATED BY THE RADIATOR SIDE OF THE ENGINE UPPER SENSOR. GOOD
...oxygen sensor? Your fuel filter is on the firewall and the oxygen sensors are on your exhaust. There are four of them on your vehicle. I dont think either of those are your problem. I would check the ...
...oxygen sensor - somewhat expensive to replace (they cost about $40-60 just for the part), but since the oxygen sensor is the thing that tells the engine whether it's feeding too much or too little ...
Usually answered in minutes!
262 Questions
205 Questions
165 Questions
134 Questions
121 Questions