motor overload protector kicks in. This would also make sense that it started happening in the Spin cycle when the motor draws the highest voltage. Sometimes it's only the overload protector that goes
...MOTOR THERMAL OVERLOAD PROTECTOR: The electric motor has a manual thermal overload protector. If the motor overheats for any reason, the thermal overload protector will shut off the motor. Turn ...
Question about Threaded 1.5hp Fullrate 115/230v
overload could be bad but if the motor has burnt windings then it probably is pulling too many amps which will cause the overload. Sounds like you need a service call or take the motor to a motor shop
Question about Threaded 1.5hp Fullrate 115/230v
it does pump water and the motor trips overload, the only thing left to check is the overload. Check the motor's amp draw and if within specs, replace overload. If amps are too high, replace motor
...a motor has a thermal overload that must be manually reset then there should be a button on the motor, often red. While the motor is de-energized (power plug removed) , push the reset button by
Question about Threaded 1.5hp Fullrate 115/230v
...TO START" Check main motor over load in compressor electrical panel and manually reset overload. Then reset main motor overload on controller. The main motor overload has to be reset manually
...overload switch An electric motor used in lots of equipment may include overload reset button on the motor body. If the motor is overloaded or if it overheats, this button will pop "out" indicating ...
...motor overload, broken power cord or failed drive motor can prevent the table saw motor from starting. First, try resetting the overload. If the table saw motor won't start after resetting the ...
motor/fan overload on a copco atlas zt22 We continually have an alarm that indicates fan/motor overload. what would be the steps in troubleshooting this issue? we increased the trip from 25amp to 30 ...
Question about Threaded 1.5hp Fullrate 115/230v
...Overload: The motor may be overloaded and drawing too much current. Check the load on the motor and make sure it is within the motor's capacity. Short Circuit: A short circuit could be causing the ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions