break the sander spins so fast without the white break and when i put the break in, it strains the motor and does not function properly dewalt has a web sit where they answer your questions
and remove a thin layer of wood with each pass. The orbital sanding sheets go on another tool called an orbital sander. Write back if you find the sander and can not figure out how the sheets go on it
Question about BO5010 5" Random Orbit Sander
...but the tool is only meant to be on while in use . If the tool is really going crazy ,pull off orbital and check all screws and tighten ...
Dynabrade sander doesn't spin This is a 5" Dyna Brade sander and it barely spins, supposed to do 10,000 rpm check the exhaust muffler. or just take it off and see what happens. there is usually an ...
Question about 7800 Drywall Sander With Dust Collection
...sander everything is spinning but the orbital part. i have changed the brushes and other minor things but dont have a clue how to open the orbital part of the machine The best way to sand drywall is ...
Question about Heavy - Duty 5" Random Orbit Sander - D26451
...orbital sander. why does this sander jump around on the material and feel like it's fighting me all the time instead of sanding smooth and easy? I have the same problem with a Porter Cable orbital ...
...sander model 333 is spinning out of control. What do I do? I may not have the whole picture, but all random orbits spin wildly if they are not pressed onto the wood a little. Do you mean it is not ...
...orbital sanders. You need Makita part number 211236-8 or a bearing #6002LL. It's fairly easy to replace; remove the screw in the center of the pad and remove it. Depending on which is tighter, the ...
sander stops spinning when load is applied to the disk. The motor runs smooth, orbital movement is ok and the disk spins until even a little load is applied. Results is that is doesn't remove any wood
Question about SXE450 00458 6'' Random Orbit Sander
...sander turn on spins but as soon as i try to sand it stops spinning. It has no torque. Is it done or can it be fixed There is a ball bearing bearing on position 29 that is dirty replace it or remove ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions