...orange band has a 2mm yellow stripe on the left and a 1mm magenta stripe on the right. The DC Controller firmware is updated: cpr in the beginning and EV = 2F. I had calibrated numerous times and ...
...down on the green GO button until the orange Attention light comes on (approximately 5 seconds), and then immediately release the GO button. The green GO button will begin to blink and a ...
...down on the green GO button until the orange Attention light comes on (approximately 5 seconds), and then immediately release the GO button. The green GO button will begin to blink and a ...
...down on the green GO button until the orange Attention light comes on (approximately 5 seconds), and then immediately release the GO button. The green GO button will begin to blink and a ...
Question about LaserJet M1522nf Multifunction Printer (CC372A)
orange exclamation lights flashing & unit will not function HI, This a formatter failure, sounds like the formatter went out while trying to do a hard reset or after updating the firmware, Try
...orange x) and the ok (the green check) hold them down, then turn it on and continue to hold the keys until you get the message "permanent storage init". Release the keys and hold until the unit get ...
Question about LaserJet M1522nf Multifunction Printer (CC372A)
...the MFP printer the network cable light is illuminated orange as oppose to green. This could be a problem with the formatter board. Try an nvram hold down the down arrow and the cancel button. ...
...down on the green GO button until the orange Attention light comes on (approximately 5 seconds), and then immediately release the GO button. The green GO button will begin to blink and a ...
Question about LaserJet 1320 Printer
...orange X button. This will open the preboot menu. Use the arrow to go down to Administration, press ok and then select the option to format the disk. You will get a warning that you will need to ...
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions