Questions & Answers for: open clean paper sensor

Question about FaxCentre 1008 Plain Paper Laser

1 Answer

...to clean? Many thanks in advance. Regards It Is a sensor that you should clean or re-locate. Try searching on sides of the roll or near the place where it shows you or tell you about the paper

Ad

...clean and nothing is out of the ordinary. It got a paper jam the other day, i cleaned it out and now ever since then the paper jam light wont go away. Any ideas on what could be the problem? The ...

Ad

Question about TS-4500 Shredder

1 Answer

clean your keyboard out. Since the opening for the paper or the Thoat width is 9", the switch should be close to 4.5" towards the center. To try to help you located the sensor, take a piece of 8 1/2 "

Question about B4100 Laser Printer

2 Answers

...paper jam, open upper cover message. I suspect jammed sensor, or small piece of paper corner remaining, but none visible. I am handy at computer repair, etc. I s there on line service manual to show ...

Question about B4100 Laser Printer

3 Answers

...open the rear access door by pressing in on the left side tab and then pulling the door toward you. Figure 2: Removing the rear access door Inspect the pressure rollers on the rear access door and ...

Question about PanaFax UF-8000 Laser Fax

1 Answer

...It grinds when starting up and says there is misfed paper. Don't see any. Paper feeder sensor guide is open or displace ,So it said misfed paper.Clean sensor or right position set the sensor

Question about PanaFax UF-8000 Laser Fax

1 Answer

Open the paper draw and check that the paper orientation matches he operation panel. mite be a fuser unit drive problem. Open the front door and using some paper acturate the door sensor, allowing you

Question about AR-5316 Advanced Digital Imager Copier

2 Answers

...not broken. also open cassete and see inside no paper jam there check your sensor connector or clean sensor or small black thing is on there, in own place. check the sensor with simcode 30 - sub ...

...sensor located just below the sensor flag shown in snap shot, if you are tech guy you can open and clean it other wise blow pressure air to clean with out open the printer.Thanks ...

sure the little plastic sensor is swinging free. That sensor tells when the tray is empty. Follow the paper path thru the printer checking all the sensors to make sure they are "opening" and "closing"

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66772 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...