Questions & Answers for: onkyo protection mode

Onkyo Tx-v940 Receiver/Amplifier Protection Mode In trying new speakers, amp went into protection mode and now front display will not work. Main Power works. Anything advice to take it out of ...

Ad

Question about TX-SV454 Receiver

2 Answers

...mode Hello, My Onkyo TX-sv454 is stuck in protect mode. I opened case and I don't see any problems. Is it possible for me to reset it. Thanks i believe protect mode is because you have the wrong ...

Ad

Question about M-282 2-Channel Amplifier

3 Answers

ONKYO TX-SV717PRO Amplifiier Stuck in PROTECT MODE fuse is o'k. Can't get passed PROTECT mode. disconnect power and try after 20min without speakers. Towards the back of the users manual there is a ...

Question about TX-8511 Receiver

1 Answer

Onkyo tx-sr800 PROTECT mode how can i reset my receiver out of PROTECT mode Hold video1 and press speakers A button, it will say "clear" If the message protect appears again, then its service time.

onkyo ts595 goes into protect mode with volume increase I have two ta595 receivers that do the same thing, the go into protect mode with volume increase past 40 on display Hello, Since moving the ...

Question about TX-SV727 Receiver

2 Answers

...mode Onkyo Tx Sv 727 7.1 av receiver goes to protect mode. i noticed some transistors on the pre-amp circuit board(where the volume control is)is getting very hot, i replaced some faulty onesand ...

mode Onkyo receiver TX-SR600? My receiver is in the Amp protect mode. How do I reset my amp / receiver from protect mode ? if your receiver is in protect mode then that is one of two things. one there

Question about TX-8511 Receiver

1 Answer

my receiver is in protect mode..what does that mean See reasons for protect mode on onkyo site. Most likely the speaker wires are shorting or are reverse polarity. see connection diagram.

Question about TX-8511 Receiver

1 Answer

...ONKYO tx 8511 is protect mode How to reset Hi Vinoth, if this has not been resolved I would advise you to disconnect the unit from the AC Outlet for at least an hour and then see if it is out of ...

...onkyo tx-nr828 that will not power on To check protect mode: what kind of protection it belongs to when NG channel is displayed such:NG:LCRSLSRBLBRNG__CH:LCRSLSRBLBR1.Press the Enter button2.Protect ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...