Questions & Answers for: oil stick

...oil from the dip-stick position. Removing the drain bolt is a messy job, as you need to catch the oil in a drip pan. To siphon oil, simply use a household syringe, but remember to keep this clean so ...

...oil dip stick in the 1998 Saab 900 where is the oil dip stick in the 1998 saab 900 u can find it near gear oil stick yellow colour It's where you check the oil. Take the oil filler cap off and dip ...

oil but my dip stick is showing way too much oil, what is going on? At first I had a hell of a time getting the drain plug out, but finally did. Drained the oil, replaced the filter, replaced the plug

...stick hot shows the oil level at the 2nd x mark on the stick , the stick has about 5-56 x marks between add and full , does it need oil added ? yes until the the oil reaches full on the dipstick you ...

...DIP STICK BELOW THE FRONT VALVE COVER.LOOK ON THE OIL LEVEL DIP STICK WHEN ADDING OIL DONT OVER FILL THE FULL MARK LINE ON OIL DIP STICK THAT WHERE YOUR OIL LEVEL SHOULD BE DONT GO PASS THE FULL

...oil dip stick with a clean paper towel and dip stick look dry no sign of oil add little oil at a time see if oil level reach add oil mark or the full mark.if oil is low. low oil light will turn ...

...ground --engine running while checking oil -or not swiping stick clean before reading it these are reasons for high reading on dip stick oil pressure sensor/switch only measures the pressure of the ...

oil level dip stick. 4). Remove the dip stick and wipe clean with a dry cloth. 5). Reinsert the dip stick and make sure it is firmly bottomed out against the stop. 6). Remove the dip stick and observe

oil dip stick from engine 5. and clean the dip stick on a rag. 6. Put dip stick back in engine 7. pull out again and check the level showing on the dip Stick 8. If level is too low on dip stick and is

...oil where the dip stick is at. I want to tell you when you add oil, the oil tend to get on the dip stick when you try to check the level.. To get a good reading on the dip stick you may have to check ...