...service make sure engine oil/air/fuel filters are changed when beeing serviced check charging rate,aux belts etc reset light MAINT light indicates that you need to change engine oil. You or your ...
Question about 2008 Sienna
...Service Tool I am trying to change the oil filter on a 2008 Toyota Sienna. It is asking for a 'special service tool' to remove and replace the oil filter. Where do I find one? Called the Toyota ...
...every 7.5k miles and use a good brand SM rated oil. After service the light is to be reset. Hold in the trip odometer button and while holding in, turn the key on, it should reset (off) in 5
...oil and filter change, and finally as complicated as, timing belt/chain replacement, if you decide to service by yourself, I recommend to Haynes Repair Manual, Specific for your car. For your car ...
...service, oil light came on. dealer topped up with 0.9 litres, is this excessive? Car has only done 33,,000 miles and has full dealer service history Several ideas. 1) When the dealer completed ...
Question about 2002 Corolla
...hydraulic adjuster , cam shaft seals idler pulleys , crank seal will be less than that one job so get quotes from around accredited service shops check the oil level weekly and keep it on the full ...
Question about 2002 Corolla
...oil, and haven't had the recommended service. Do it now. Ask them to find any oil leaks you may have. If they find none, keep an eye on the oil level until you know why. Older cars most people check ...
Question about 2002 Corolla
...service book oil and filter 10,000 miles or 6 months which ever comes first auto oil around 60,000 miles unless it is smelling burnt timing belt at 60,000 miles brake pad check every 30,000 miles ...
Question about 2002 Corolla
...remains on .The car has had a full service in the last week .Please advise . The "full service" did not include doing the oil change correctly. You may be driving with too little oil and/or a ...
Question about 2015 RAV4
...oil used during last service is incorrect ( too thin?) ? Personally I would have changed with correct oil, and start there. You may have a bad oil level sensor,or connector or wiring. Good Luck P1604 ...
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,231 Questions