...seals shrank and oil leaked from crankshaft seals and rocker cover seals. If the rate was higher, the seals swelled a little extra and the engine was tight. Then if the owner changed back to mineral ...
...so if anyone can tell me what the problem is i would be very gratefull thanks toney Check your oil level, too little is never good but too much oil can cause smoking and is also pretty bad for ...
I just brought a 93 zr1100 and I have now manuel. I need to change the oil. Is there a drain plug on the bottom of the motor or just the filter? Thanks Eric You can do a free download of a factory ...
kawasaki zephyr 1100 not running right i bought a kawasaki zephyr 1100 which hasn't run for 13 years. i've had all the carbs off and cleaned them out. the main jets and the idle jets are all clear but
...online. www.babbittsonline.com/pages/parts/viewbybrand/default.aspx The process is to drain the oil, remove the engine, clean the gearbox free of dirt, flip the engine upside down, then split the ...
how much oil do i need in each front fork ? buy some graduated plastic containers let all air out of forks put new empty container below forks and let it drip into bowl then pump forks up and down a ...
transmission oli You bikes oil lubricates the engine, clutches, and the transmission. 10w-40 MOTORCYCLE oil is what it uses.
how much fork oil do I put in each leg of my zephyr 1100 Is you have taken the forks apart and changed the fork bushes, ie forks are totally dry, you will need about 520ml in each fork leg. When ...
engine oil capacity please Oil capacity will be stamped on the side of the engine either near the viewing window or the filler hole
...1100 1993 10000miles from new, clunky gear change. I've fitted a new clutch and Castrol 1 10-40 oil and new filter, still crunching when changing gear any ideas? Hi, Royston you may have some ...
Usually answered in minutes!
16 Questions
11 Questions
8 Questions
4 Questions
2 Questions