may need to add oil to trans how an where do you add aotomatic trans oil to 08 colbalt The Cobalt transition is sealed and do not have a place to user/owner-refill the oil. The oil should work fine 50
front oil seal on a 1996 metro geo THE FRONT TIMING COVER OIL SEAL HAS TO BE REPLACED.BY REMOVING THE TIMING COVER.YOU HAVE TO USE SEAL DRIVER TOOLS.YOU ALSO CAN REMOVE TIMING COVER OIL SEAL WITH THE ...
How do I find out if the oil leak is from my oil filter or from the oil plug? How do I fix both? You will see oil around the plug or the filter. Replace the one that is leaking First thing you have to
How tight does my oil plug have to be? tight enough to not leak. check if its sealed withan o-ring if so snugg is ok if not get it tight about 25-50 lb of torque 10 Ft. Lbs. should be plenty. If you ...
Where is the transmition oil measuring wand located in my 2006 Chevy Cobalt. this is a sealed system needs to be chevked at service center if there is a problem if not no need
...which means that you have to take it to the shop in order for them to tell you if it needs oil or maintenance. There are no sealed transmissions Transmissions can not go 100,000 miles nor
...Remove the MAP sensor and seal. To install: Lubricate the NEW MAP sensor seal with clean engine oil. Install the MAP sensor into the intake manifold. Connect the engine harness electrical ...
...oil out and re measure what you're putting back in. Place 3 and one half liters back in as the filter holds almost a half a liter. Try not to run the car as you may hurt valve seals air filters ...
Question about 2006 Cobalt
Finding oil on ground by left tailpipe. Any suggestions of what could be happening and how to fix it? Recently replaced motor due to oil loss, which had never left a trace of oil. Engine oil is ...
Usually answered in minutes!
1,428 Questions
818 Questions
485 Questions
212 Questions
74 Questions