Questions & Answers for: kawasaki oil seals

...seals shrank and oil leaked from crankshaft seals and rocker cover seals. If the rate was higher, the seals swelled a little extra and the engine was tight. Then if the owner changed back to mineral ...

...oil to be sucked from the gearbox into the crankcase. Hopefully this is not the problem because with your model I'm 85% certain you will have to split the cases to replace the main seal on the right ...

...seals on the water pump. the oil seal and the mechanical seal. the oil seal helps seal out the oil from the trans case. the mechanical seal helps seal the coolant from going into the trans case, and ...

...oil because the seals are leaking or do you have excessive stiction in the fork? If the seals are leaking, you will have to pull the forks and add new seal and put in exactly the right amount oil. Do ...

leaky oil from small hole under the radiator pump. i have a small problem with my kmx bike,i notice a small hole at the bottom side rightside.and in every use,i could some leaky oil.is this normal or ...

...seals the oil inside the cover, however when the seal fails around the spark plug hole, oil leaks into spark plug well and out of weep hole. When the cam chain gets lose,it will rub a hole in the ...

2006 Kawasaki KLX 250 leaking oil my Kawasaki klx 250 bike is leaking oil from the bottom @ 1. Oil plug gasket 2. clutch cover gasket, 3. Center case leaking 4. TOO much oil in crankcase, 5. Shift ...

...seals with fresh oil. put back on the fork lowers in the same order they were taken off. Replace bushings at the same time if there's any brass showing. I usually do it any way since the seals ...

SEAL AT FRONT SPROCKET LEAKING OIL. THERE'S LIKE A SEAL AT FRONT SPROCKET LEAKING OIL. THERE'S LIKE A SHIM PIECE THAT FITS BETWEEN THE SEAL AND THE FRONT SPROCKET SHAFT THAT HAS FOUR LITTLE ...

2002 BMW 1150rt. Oil leaking from rear wheel studs and from the centre of the wheel rim, only if left on side stand, OiLarge oil seal was replaced together with wheel bearings and after about 5000ks ...