Questions & Answers for: Chrysler Town & Country oil change

...change my oil every 3000 miles This is valve lifter/follower noise, run a can of engine flush Have the pro's do this) through the engine, then change the oil, it might help, but as long as it goes ...

oil change reminder procedure How do I reset the service reminder on the overhead console after I have changed the oil in my 2006 Chrysler T&C? need oil light reset procedure. Have no manual Press the

...oil change, light comes on and it dings non-stop i need to know how to reset my maint. switch on my van, my oil light keeps dinging since i have had an oil change DISCONNECT YOUR BATTERY FOR TEN ...

...might want to change the oil and use an additive like "Lucas" oil treatment. And have them put in 5-30wt oil, This is no sign of a pump being bad or your oil light would be staying on. weak oil

oil on ground under van or on tail pipe. perhaps change your pcv. take out the spark plugs as well and examine them for burning oil. also it's normal to use some oil so i presume you are talking about

...Thay are very easy to change with a deep 27MM socket. Look to see if the sensor is leaking oil as this is usually a tell-tale sign that the sensor has failed Time to change oil and have the light ...

...oil change. At 28,778 dealer flushed engine to remove sludge build up and changed oil. At 30,835 miles inspection, dealer flushed engine to clean out sludge and changed oil. At 34,630 miles sludge ...

...oil at your next change(or just change it now).This stuff is thick and stringy,it helps the oil cling to surfaces.(if there is no change after this,you could try a new oil pressure switch-it's ...

...oil change could be half quart low on oil.if oil level okay check oil pressure should be 30 - 80 psi @ 3000 rpm if all is good oil pressure sending unit bad. Lift a plug wire from the coil and create ...

Recently had oil changed. Soon after, oil light started coming on w. alarm sound. We check oil and it's always full. Stops if I shift to neutral, resumes dinging when I shift back into drive. We ...