Questions & Answers for: kawasaki VN 800 Vulcan Classic ohm spec ignition wires

Question about 2001 VN 800 Vulcan Classic

1 Answer

...Most likely it will be a grounded wire. If the lights do go off you will then want to use an OHM meter to check continuity at the senders. If you get solid resistance then the sending unit is ...

Ad

Question about 1998 VN 800 Vulcan Classic

2 Answers

front axel torq specs. valcan classic 800 I need the torq spect for the front axel. I have a 1500 vulcan, on my bike its 60 lbs. According to the Kawasaki Service Manual the torque specs for the front

Ad

Question about 1997 VN 800 Vulcan Classic

1 Answer

flooding why would gas blow through hose from rear cylinder into air filter assembly check that the carb is clean and check that the float height is set to factory spec

Question about 2003 VN 800 Vulcan Classic

1 Answer

...Spec My existing regulator is rectangular. The replacement is rectangular with the corners cut off so forms a sort of hexagon Hi If it is the correct part then the wires should be the same colours as ...

Question about 2001 VN 800 Vulcan Classic

1 Answer

...ignition system and found no problems except for the weak spark. hello, if you have weak fire probably, source coil or pickup in stator, or stator itself, if its not a real blue fire, bike will not ...

Question about 2002 VN 800 Vulcan Classic

1 Answer

I have a 2000 vulcan 800 classic with the scootworks belt drive. This was installed when I bought the bike. Recently put on new tires and there is no adjustment to loosen the tension of the belt. Shop

Bike stalls when you put into gear. Clutch cable is ajusted to specs. Clutch basket and components are within specs. check sidestand switch and clutch lever lockout switch

Question about 2001 VN 800 Vulcan Classic

0 Answer

2001 Kawasaki VN 800 Vulcan Classic wiring diagram wiring ignition switch Vulcan 800 continued 12 volts at spark plugs @ Hi, Anonymous for this scenario you will need your service manual that has all ...

what would cause a 0.01 voltage drain with the ignition off? it has gone through 3 brand new batteries in last 3 months, it will run and start well for approx.1 1/2 weeks with no power drainage while ...

Question about 2003 VN 800 Vulcan Classic

0 Answer

2003 Kawasaki Vulcan only signal lights work on my 2003 Kawasaki Vulcan, my signal lights work but the rest of the lights don't work. I have checked the bulbs and the fuses and they are good, can you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...