Questions & Answers for: ohm spec ignition wires Motorcycles

...ohm meter, but you need to have the ignition on for at least one of these tests. Mine fails when the engine gets hot- both the igniter and the coil seem very heat-sensitive, and one of my cylinders ...

...outback ? Whats the ohm spec for the ignition wires on the subaru outback 2006? I want to check to see if they need replacing. I can check with an Ohm meter if I knew the spec.  Anybody? 540 ...

ignition wires worn out? Whats the ohm spec for ignition wires Most wires are around 7ohms.

...Ignition Control Unit) from 1997 Olds Cutlass Supreme 3.1L engine. Might you have the specs? I have a good ohm meter. Hand held OBD unit reports multiple random cylinder misfirings. Might it be fuel ...

...ignition module. this is under the 3 coils they sit on the ign module..You can also test and or replace the spark plug wires, if a wire is 10 inches long it should read 10,000 ohms or less.. No more ...

...cylinders, then check your distributor cap for cracks, even very tiny ones. If you have ignition coils, then check the specs with an OHM meter. The OHM meter can also be used to check the plug

...spec, go back up to step 5 If coils are bad, replace as needed and retest to confirm Step 8:(90% of the time i bet the problem is solved by now) Start engine. Perform underhood visual inspection of ...

...ohm's resistance and are within spec's. I've checked all fuse-able link's,and relay's. A friend has a 95 runner and i took all the relay's, ecu,coil, igniter and plugged them into mine and still ...

...ignition is turned on ! ohmed all 6 injectors 12.5 ohms spec is 11 - 14 ohms unpluged ecm ohmed wiring from ecm to injector connector ok ! im having trouble finding a schematic online for inj 2 15amp ...

...ignition coil and pickup coil Stator resistance should be low (probably less then .2 ohm), your looking for continuity between the 2 or 3 (usually yellow) wires but not to ground. The rotor should ...