Questions & Answers for: Toyota Camry ohm spec ignition wires

ignition switch pluugs,wires 2 times,cap&rotor3 times some times when i stop cranking it will fire on my spark tester one time only then nothing The wiring harness routing is critical on this car. Any

No Spark 1992 toyota camry Resistance values: Between coil posts(coil unconnected) = .56 ohms. Secondary coil resistance: 3.4 Kohms Signal Generator: Between G+ and G- 238 ohms Between NE+ and NE 479 ...

...spark or is there nothing to the plugs? Your ignition coil resistance should be (cold 9000-15,400 ohms) Primary should be .36-.55. Your pickup coil resistance depending whether you are California

...ignition switch, and distributor and once again as soon as I turn the key the primary coil goes to 0 ohms resistance. The plugs and wires were changed when the first coil was put in the car, I am now ...

...wiring from the component being tested ? 1MZ-FE engine Insect the primary coil resistance using an ohmmeter. Measure the resistance (cold) between the positive and negative terminals. Resistance ...

1994 Toyota Camry. I was driving on the hwy at 60mph when it just died. No fire. I had to replace the distributor a few months ago when the same thing happened. I checked the coil and found the ...

...ignition wires for resistance withing the limits 12,000 Ohms is acceptable, for most wires. Distribuitor cap and rotor for wear tune up should be done every 30,000 kms on conventional plugs / 70,000 ...

ignition problem! All wires and hoses appear to be in place and hooked up. Car dies when in reverse when i first start to back up. If you are saying the engine speed does not change with the gas pedal

...engine compression is 140-psi in all cylinders new fuel pump and injectors the crank and cam positionsensors are within spec the ignition coils are in spec Do you have normal fuel pressure and spark

...circuit, power and ground fuses that look good can in fact be bad, (hair line cracks) so use the OHM meter part of you meter, and check for 0 ohms good infinity ohms bad, works 100% of time , ohms ...