torque specs Need the torque specs for the flex p;ate to torque converter bolts. This is for a 1997 subaru 2.5 engine. 25 foot lbs
Question about 1997 Outback
ignition on, there is a strange buzz under the hood by the firewall above the transaxle which was not there before. Is there a way of testing either the relay or the pump with an ohm meter? Thank you.
Does anyone know the ohm spec? Thanks Mike P. Don't know the actual resistance but the general resistance I use that has not let me down is 1000 ohms per foot and not more than 10,000 ohms on any wire
...outback ? Whats the ohm spec for the ignition wires on the subaru outback 2006? I want to check to see if they need replacing. I can check with an Ohm meter if I knew the spec. Anybody? 540 ...
ignition wires worn out? Whats the ohm spec for ignition wires Most wires are around 7ohms.
... (Fuse is okay!) check that the ground wire is connected to ground. You can test the switch with an ohmmeter in the ohm position to see if it's good. You can test power to the switch from the battery ...
...would raise the resistance. If you can remove the fuel sender unit from the tank, you can use an ohm meter to check its resistance. When the float is low, you should see a resistance of around 100 ...
...wires, plugs, etc are in place all fuses are good. I am getting fire on cylindars 1 and 2 but not 3 and 4. I replaced the car computer still the same result. Can you help hi the only thing i can ...
central locking module key fobs have new batteries but operation lock/unlock doors is intermittent. Works fine only if car is in the sun or hot after a long drive. clean the ir sender on the ...
Question about 2014 Outback
On the 2014 Outback, what is the ignition and starter fuse number ? On which of the two harnesses is it located? Hello Michael Blell, I went through all my favorite sources for repair information... ...
Usually answered in minutes!
315 Questions
235 Questions
240 Questions
223 Questions
176 Questions