Questions & Answers for: Subaru Legacy ohm spec ignition wires

...wires leading to the ignition switch. Would it be possible for you to check the voltages of the wires on that switch (using a DVM)? You could also try running a jumper wire from the + terminal of the ...

...spec's. Originally, had a PO103 code along with a PO325 knock sensor code. Resistance was out out range and replaced the sensor. The resistance on the coil reads good but I haven't seen it on the ...

90 Subaru Legacy with no spark 90 Sub Legacy 2.2l that won't start. I checked the timing, replaced the ignition module, crank angle sensor, camshaft sensor, and had the coilpack tested at Autozone ...

ignition system. No adjustment is possible/necessary. The computer adjusts the timing continuously. You can check the timing if you have a timing light. The spec for engines with a turbo charger is 15

...ignition on produces no fuel from the line going to filter. How do I know if it's the pump or the relay? Take your back seat off, just the lower part. The two bolts are near where the passengers feet ...

...ohm resistance between the 1 and 2 outport tell me the ignition coil is bad? I was told the resistance should be 0.59 to 0.75 ohmns. The ignition coil is from a 1991 legacy ,four cylinder,non turbo. ...

...ignition wiring a couple of years ago. To check these you need either a spark gauge which can be found at any auto parts store for a couple of dollars or a multimeter to measure the wires' ...

...wires or exposed conductors. If you can see if you can have a scanner connected to the car to be sure. There may be error codes stored in the computer. Some shops would let you borrow their scanners. ...

now start when key is turned changed battery Left headlights on killed batt replaced with new one now wont roll over I have lights on dash and power out of ignition and relay but not at starter I can ...

Specifically I'm trying to identify the wire on the spark plug coil assembly to which I should connect the signal wire of a Tachometer to. The wire colours are, red, yellow, green/white, and blue. I ...