Questions & Answers for: Pontiac Grand Prix ohm spec ignition wires

Question about 1998 Grand Prix

1 Answer

...ignition key can then be turned to the LOCK position. The key can then be taken out of the cylinder. I have 11.53v on the power side and ground side to battery has 11 ohms ? do a voltage drop test on ...

Ad

...Ohm reading was 2M ohms. The good one read 1100 ohms. Still not good. I know how to check the wire harness that go from the sensor to the frame. How can I check the wires from there to the BCM. I do ...

Ad

wires, ignition module,gas filter,checked ohms on coil packs, all 3 test close to identical.Every once in a while, all the guages drop to zero for a while but doesn,t seem to affect it much. When that

...OHM meter, and the specs for the resistance in the manual. So can the ignition coils. Change fuel filter...easy. Last, if you have scanner...check MAF(mass air flow sensor) for operating ...

Question about 2005 Grand Prix

1 Answer

...ignition coil there is no spark to the spark plugs chances are it is the coil although it sounds pricey its really not there pretty cheap and easy to replace if you have a volt meter try ohming it to ...

Question about 1994 Grand Prix

1 Answer

ohm reading to start. I'll take the risk of someone stealinga 94 grand prix in 2011 There is no way to override the security system that I know of.You probably have a bad ignition cylinder.This is the

Question about 2000 Grand Prix

1 Answer

...and watch the fuel gauge if the gauge works ok thats makes 100% sure its the sending unit. At 245 ohms the gauge should read full, 180 ohms for 3/4 full, 160 ohms for 1/2 tank, 100 ohms for 1/4

...OHM meter, check across your old key at the chip and write down the ohms of resistance. Then do the same with the new key. If they are not the same OHMs the new key won't work unless you have the ...

...wires to help check they are coming from or where they are going to. You really need to find a friend with some knowledge to help you. just remember that you have to a 12 volt line coming in, 12 volt ...

...ignition switch. i ALSO RECOMMEND CHECKING ANY GROUND WIRES TO SAID LIGHTS AND TO WIGGLE THE TURN SIGNAL LEVER WHILE CHECKING IF BLINKER FLICKERS AND WORKS POSSIBLE TURN SIGNAL FLASHER ISSUE TOO you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...