Questions & Answers for: Oldsmobile Cutlass Supreme ohm spec ignition wires

...wires go to but unable to trace to ignition module. please help. double check all connections and make sure they are completly seated and locked into place, other than that buy a new ignition module ...

...IGNITION SWITCH. THE CAR OF COURSE DOESN'T RUN AS ROUGH WHEN STARTED NOW THAT THE LAWN MOWER CHAMPION PLUGS HAVE BEEN REPLACED (PREVIOUS OWNER) BUT WANDERING HOW OFTEN THE HEAD GASKETS NEED RESEALING ...

...ignition and wires! re-install the same way it came apart! if you take it out and deside to try to fix the wire instead of buying new ( not recomended ) you have to solder the wires together because ...

...Ignition Control Unit) from 1997 Olds Cutlass Supreme 3.1L engine. Might you have the specs? I have a good ohm meter. Hand held OBD unit reports multiple random cylinder misfirings. Might it be fuel ...

...the units within the distributor, the following tests can help pinpoint the defective component. An ohmmeter with both high and low ranges should be used. These tests are made with the cap assembly ...

...wires in the ignition broke.i tried to put them together and start.need to disable if you have the key it not hard buy a resitor pack from radio shack have some one read the ohms across the key cut ...

ignition module does test out alright then the problem could still be in the pick-up coil/stator, (it can be tested using an ohm meter by dis-connecting the wire connector from the pick-up coil/stator

can not get car to crank by switch but can only turn over by putting wires together under hood what do you think i should try? check ignition switch put 12 volts to the ignition feed wire at the ...

wires do go to the battery post or large terminal of the starter. The smaller purple wire is the ignition feed to the starter solenoid, and is connected to the small post of the starter solenoid. When

...ohm at 11.8 and within .1 of each other. I have power at the PCM at the battery and the ignition wires. I have 12 volts to the injectors. I hooked up the noid light and I get no pulse. I had the ICM ...