Questions & Answers for: Lincoln Navigator ohm spec ignition wires

Question about 1999 Navigator

1 Answer

1999 navigator I have a factory installed anti theft system. I purchased an alarm switch that works, however, the system is a DEI self starter, which my alarm switch does not support. Aside from the ...

Ad

Question about 2001 Navigator

1 Answer

torque specs lincoln anyone know the torque specs for an 01 navigator trans pan 10mm heads Depends on which transmission you have. 4R100 = 11 ftlbs 4R70W = 10 ftlbs

Ad

...the walls. Then touch the other to the wall and you should get a resistance value less than 1M Ohm. If the resistance is extremely high, then you have an open circuit, which could be caused by a ...

...and plugging it back in, corrosion on the leads can cause a misfire. also if you can use a ohm meter you can check the resistance of the coil. check between the two leads and the wire where ...

Question about 2003 Navigator

3 Answers

...wires in the connector (THAT HOOK UP TO THE RELAY). The air ride compressor and the air ride solid state relay share the same ground which is the light green and red wire. Turn your volt ohm meter to ...

Question about 2006 Navigator

1 Answer

...fuse: Fuse F1.5 (7.5A). Measure the resistance of fuse F1.5 (7.5A). Is the resistance less than 5 ohms? Yes GO to D4 . No GO to D3 . D3 TEST CIRCUIT 729 (RD/WH) FOR A SHORT TO GROUND Disconnect: ...

Question about 1999 Navigator

1 Answer

...ohm on electronic ignition type coils. Secondary resistance values vary widely, so consult a specifications chart for the engine you are servicing. If a spec chart isn't available, compare ...

...TEST FUSE 5 (7.5A) Check fuse: Fuse 5 (7.5A). Measure the resistance of fuse 5. Is the resistance 5 ohms or less? Yes GO to A4 . No GO to A3 . A3 TEST CIRCUIT 729 (RD/WH) FOR SHORT TO GROUND ...

...tank. put an ohm meter across the wires to see if the fuel lever is working. take the fuel lever out of the tank and inspect. Be carefull not to smoke or create a spark while working on the gas

...ignition when pushing the shift button manual overide works but no brake lights. Yes , with a volt meter . Find the switch an back probe wires ,testing for voltage in , then press the brake pedal an ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...