Questions & Answers for: Jaguar S-Type ohm spec ignition wires

Ground wire Issue ??? This is a strange one. My car will not start unless I turn the ignition key and blow the horn at the same time. I'm figuring it is a loose ground wire, but Im not sure which one.

how do i put a coil in a 2001 jaguar s type 303-07A: Engine Ignition ? 3.0L (4V) 2001 Lincoln LS Workshop Manual DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil

...key off something is remaining on draining the battery.I dont have a manual,but offer this.take a ohm meter put it on 10 remove the battery ground place the ohm meter between the ground cable and ...

wires connected to the battery and the ignition switch.And also the fuse that is connected to the ignition switch from the brake circuit. Then replace those worn out or destroyed wires, fuse and brake

...coil. At the coil,measure the resistance across the primary windings.It should measure between 0.50 Ohms ans 1.00 Ohms. I hope this information is helpful.If you need anything else,don't hesitate to ...

...and see what effect it has on the idle speed of the car. Or if you have a multi meter set it on ohms and read the values of the coils and look for an odd reading. Hope this helps - good

2002 jaguar s-type. had plastic in ignition switch. pulled out switch got it out and put back in and it will not start car what about the transponder have you damaged it ,or forgot to put the wiring ...

...sure the ignition relay is energised. Measure the voltage between:-Is the resistance greater than 5 ohms? -> Yes REPAIR the high resistance circuit. CLEAR the DTCs. TEST the system for normal ...

s type jag electics go haywire when put through a carwash alarm gos of lights flash , ignition key comes out and engine continues running Sorry dude but it sounds like the wiring in your ...

2003. Replaced engine. Why won't it crank using the ignition switch but will crank manually? not wired properly would be my first guess .