...spec, the secondary was high by 5K ohms. Well, I have replaced the coil. Problem went away, for a couple of days. But back. Problem is, it stalls. At idle, during accelleration, decelleration, ...
...ignition switch,the wires, the fuses, the ignition assembly ,the rotor coil, the starter solenoid and the connection of the ignition switch to the battery . If there is a worn out or destroyed spare ...
How do I perform a continuity test on a 2002 dodge dakota power window lock? a continunity test is nothing more than making sure the fuse is not popped. or a wire is not broken, or a switch is not not
...ignition. Fuel: Need to test that line pressure is within spec, injectors are working (resistance is usually 12-14 ohms) Air: Check for proper vacuum, air filter, air path Compression: usually does ...
ignition coil harness connector at the coil. Connect a set of small jumper wires (18 gauge or smaller) between the disconnected harness terminals and the ignition coil terminals. Terminal locations on
...the mass air sensor, is connected and works, check with an ohm meter and see if it ohms out or if its an open circuit. if its open replace it. also check any wires and connectors for
...wires. Looked at all connectors I may have bumped and disconnected found nothing loose. Now no power to ignition coil or fuel pump. Have engine codes 11, 12, 16 and 36. Tilt steering wheel column is ...
tune up specs what engine size 2.5 3.9 5.2 need engine size give you ignition timing.idle speed. spark plug gap.
Question about 1997 Dakota
...position when at tdc ? I replaced distribuator and cant remember At TDC the ignition rotor needs to be aligned with #1 on the cap. +/- 4 degrees. A scanner us helpful in determining the exact
...ohm meter ? You can check out wiring diagrams at http://bbbind.com/free_tsb.html ! The ASD - auto shut down relay power's up the fuel pump relay , ignition system an some other thing's . It's in the ...
Usually answered in minutes!
1,021 Questions
870 Questions
712 Questions
723 Questions
618 Questions