Ignition I had a bad motor, found a replacement a lot cheeper than rebuilding origional motor. The original motor ran, swaped only the motor and generator stator. I have no spark at the plugs. I ohmed
...ignition coil, sanded where the bolts touch the iron core and where the iron core touches the stator plate. even sanded the connection where the condensor mounts as well as where the points attatach. ...
...ignition stop switch. 4) check coil. a- primary coil, b- secondary coil. 5)check cdi coil. a-pickup coil. b- charging coil. Since you have replaced the coil I will only give specs for the cdi check. ...
...ignition coil from the ignitor. also i would like to know which pin is what on the connector that connects the ignitor. Any help on where i can find this info would be greatly appreciated. also i ...
...ignition coil, stator coil or the CDI control. I believe you can ohm these three parts out, not sure what the resistance specs are for any of these three parts? I would like to know if I can ...
Question about 1972 DT 360
...day. XJ PARTS CATALOG SECTION ELECTRICAL SYSTEM Ignition System Look through whole section coil specs are there 81 xj 650 maxim spark wires and resistor questions Yamaha XJ750 Owners Workshop ...
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions