Questions & Answers for: Subaru ohm spec ignition wires

...spec's. Originally, had a PO103 code along with a PO325 knock sensor code. Resistance was out out range and replaced the sensor. The resistance on the coil reads good but I haven't seen it on the ...

90 Subaru Legacy with no spark 90 Sub Legacy 2.2l that won't start. I checked the timing, replaced the ignition module, crank angle sensor, camshaft sensor, and had the coilpack tested at Autozone ...

...SHOULD BE 15 DEGREES BTDC +OR- 8 DEGREES.U CAN NOT ADJUST THE TIMING IF IT OUT OF SPEC. THEN U HAVE A TIMING BELT ISSUE OR A PROBLEM W/ THE IGNITION CONTROL SYSTEM.THE VEHICLE COMPUTER CONTROLS ...

Does anyone know the ohm spec? Thanks Mike P. Don't know the actual resistance but the general resistance I use that has not let me down is 1000 ohms per foot and not more than 10,000 ohms on any wire

...outback ? Whats the ohm spec for the ignition wires on the subaru outback 2006? I want to check to see if they need replacing. I can check with an Ohm meter if I knew the spec.  Anybody? 540 ...

ignition wires worn out? Whats the ohm spec for ignition wires Most wires are around 7ohms.

...ohm resistance between the 1 and 2 outport tell me the ignition coil is bad? I was told the resistance should be 0.59 to 0.75 ohmns. The ignition coil is from a 1991 legacy ,four cylinder,non turbo. ...

...ignition coil - have you tested for ohms resistance? (in particular cylinder #3) the coils are relatively inexpensive, and easy to test for sure. I think it is 10 ohms or less if I recall - similar ...

...ignition wiring a couple of years ago. To check these you need either a spark gauge which can be found at any auto parts store for a couple of dollars or a multimeter to measure the wires' ...

ignition on? If not the connection from the dash board to the alternator is not there for what ever reason, might be the wiring loom of the bulb, or the alternator it self. If this all works its worth