Questions & Answers for: Harley Davidson ohm spec ignition wires

...spec's from the manufacturer or web site. the primary side could be from one ohm to 3 to 5 typically, could be more depending on coil. you can also check the ohms on the secondary by probing the ...

...ohm meter lead from ground and insert into other hole on alternator plug, resistance should be .2 to .4 ohms (pretty hard to read) but if resistance is lower, stator is damaged and needs replacement. ...

...ignition module to coil and plug wires switched - Aft cylinder still did not fire. (Coil good) Lead wires from module checked, intact, no apparent damage. Module removed from nose cone, inspected, no ...

ohm meter and they test within spec. I have also tried new spark plugs. Looks like the ignition module or crank position sensor. Some carb models also have a cam position sensor. Get the trouble codes

...ignition coil and pick up coil with a voltmeter. The only thing that was not up to spec according to the manual was the pick up coil. The resistance between the pick up body and the metal contact tab ...

wires because you will also be reading the ohmmeter internal resistance and/or the wire and lead resistance added to the primary wiring resistance. You can also test the coil by leaving the "hot" wire

...ignition switch wire to ground issue Hi, Gina before testing any electrical component in the Charging System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able ...